BEFORE YOU DRIVE OUT OF YOUR GARAGE,YOU MUST DO THIS!

WHAT YOU MUST DO DAILY/WEEKLY TO KEEP YOUR CAR RUNNING OPTIMALLY AND MINIMIZE THE COST OF MAINTENANCE.

Vehicle Maintenance Checklist

In this section, we highlight a list of vehicle components that should be checked on a routine basis to keep your car running its best, to help you avoid costly repairs and to extend the life of your vehicle. Be sure to always wear safety.

ü Check the Oil

ü Check the tire pressure

ü Check the battery

ü Check the coolant

ü Check the windshield wiper fluid and blades

ü Check your lights

ü CHECK THE OIL

Motor oil is designed to lubricate, cool and seal internal engine components. That’s why regularly checking and changing engine oil is an important part of overall vehicle Maintenance. Running the engine with little or no oil will cause the engine to overheat and eventually seize up. Neglecting to change the oil periodically will shorten the life of your Engine.

Ø Start your vehicle and warm up the engine. Park the vehicle on a level surface and turn off the engine. Wait 2 or 3 minutes to allow the oil to drain to the bottom of the oil pan.

Ø Open the hood and locate the engine oil dipstick. Refer to your vehicle Owner’s manual for the exact location.

Ø Pull the oil dipstick out of the tube and wipe off the engine oil with a clean shop Rag.

Ø Reinsert the dipstick into the dipstick tube all the way.

Ø Pull the oil dipstick out and check the oil level. The oil level should be between the Min and Max marks on the dipstick.

Ø Add oil if below the Min mark. It takes one quart to raise the oil level from Min to Max.

ü Check the tire pressure

Tire pressure is often overlooked, but it directly influences how a vehicle performs on the road. Low tire pressure can affect handling, overall ride and fuel economy. Over-inflating tires can cause the vehicle to ride hard, and the tires to wear prematurely. It’s also important to know that temperature directly affects tire pressure. Be sure to check your vehicle’s tire pressure on a regular basis. For even more tire care tips, click here.

ü Locate the tire’s valve stem.

ü Using a tire pressure gauge, hold the gauge down on the valve stem to get the tire’s pressure reading. Perform this step for all of the tires on your vehicle.

ü Compare the tire pressure to the information on the sticker located on the driver side door jam. Please make sure that the tires are cold and have not been driven on for at least an hour as the tire’s air pressure will increase as the temperature of the tire increases.

ü If needed, inflate the tires to the manufacturer’s specifications.

ü Check the battery

Your car’s battery stores the electrical energy necessary to start your vehicle’s engine and power electrical components while the engine is not running. The battery should be secure to prevent damage, and the cable connections should be clean and tight to allow the proper flow of electricity. Most car batteries are a sealed lead acid type battery that lasts from three to five years depending on driving conditions. If your engine turns over slowly, this is a good indication that your battery is nearing the end of its life. If your car does not start at all, chances are, your battery is already dead. Replacing a battery is not a difficult job on most cars, just remember to wear hand and eye protection.

Ø Using a digital multi-meter, check the battery voltage with the engine off and the battery cool. A digital multi-meter is reasonably priced and easily available at your local auto parts store. The best time to check a battery is in the morning before you drive. A fully charged battery should read about 12.6 volts.

Ø Inspect the battery posts and cables for corrosion. Corrosion is a white powdery or chalky substance that forms on top of the battery.

Ø Check the date code on the battery to determine the age.

ü CHECK THE COOLING SYSTEM

Cooling system failure is the number one cause of mechanical breakdowns on the road. Checking the coolant level, mixture, and condition on a regular basis could prevent you from being stranded. Coolant/antifreeze usually contains ethylene glycol or propyleneglycol, and other additives. It raises the boiling point and lowers the freezing point of the cooling system when mixed with distilled water. A 50/50 mixture is recommended for optimum performance. Litmus paper and antifreeze testers are readily available to test the condition and mixture. To check the coolant level, follow the steps below.

Ø Turn off your car and wait until the engine is cool.

Ø Open the hood of your car and locate the coolant reserve tank. It is usually a clear or white plastic tank that is connected to the radiator with a hose. Lines printed on the outside of the container will indicate whether or not the fluid level is high or low.

Ø If the level is low, unscrew the cap of the reserve tank and pour in a 50/50mixture of Antifreeze/Coolant and distilled water. Use a funnel to avoid spillage.

Ø If the reservoir is empty, you may need to add coolant to the radiator as well.

Remove the radiator cap (be sure the engine is cool) and add coolant until you can see the top of the fluid level inside. Be careful not to overflow.

Ø If your car doesn’t have a reservoir for Antifreeze/Coolant, pour the fluid directly into your radiator. Again, be careful not to overflow.

Ø When you’re finished, reinstall the caps. Remember, most coolants are toxic, so don’t leave open containers or leftover coolant lying around for children or pets to ingest, as it can be fatal.

Ø CHECK THE WINDSHIELD WIPER BLADE AND FLUID.

Windshield wiper fluid and blades are essential to keeping your windshield clean while driving. It’s important to service your wiper fluid and blades regularly since the blades can dry and crack from the sun, or wear down from regular use. Wiper blades that skip, streak or leave spots or smears should be replaced.

Ø Turn off the engine and open your hood.

Ø Locate the windshield wiper fluid reservoir (typically a clear to white-colored jug filled with blue windshield washer fluid). Be sure not to mistake it for the coolant reservoir which can look similar. The coolant reservoir will be connected by a hose to the radiator.

Ø Open the reservoir.

Ø If the level is low, usually less than three-quarters full or below the “Fill” line on the jug, pour windshield washer fluid to the top of the container.

Ø Examine your windshield wiper blades for damage and wear. When operating , if the blades skip, streak or leave spots or smears, they should be replaced.

ü CHEACK YOUR LIGHTS

Your car’s headlights, taillights, brake lights and turn signals are essential in not only helping you see clearly while driving, but in helping others see you clearly too. Headlight and taillight bulbs are readily available from your local auto parts stores, and they are (in most cases) easy to change. It’s important to make sure all of your vehicle’s lights are working properly, especially since you spend most of your time inside your vehicle and might not know when one of your lights is not working.

o CHECK YOUR HEAD BULBS

Ø Turn the key to the on position.

Ø Turn on your headlights and put them in the high beam position using the headlight controls next to your steering wheel.

Ø Exit the vehicle and go to the front of your car to inspect whether your high beam bulbs are working for both headlights.

Ø Re-enter your vehicle and put your headlights in the low beam position using the headlight controls next to your steering wheel.

Ø Re-exit the vehicle and go to the front of your car to inspect whether your high beam bulbs are working for both headlights.

o CHECK YOUR BRAKE LIGHT BULBS

Ø Have an assistant (friend or family member) step on the brakes while you inspect the lights at the rear of your vehicle.

Ø Locate any burned out brake light bulbs.

o CHECK THE TAIL LIGHT BULBS

Ø Turn the key in the on position.

Ø Turn the head light switch to on.